technical question

[Rasteddy]

I was wondering which techniques you all use if the middle whole of your LP/single is too small to fit smoothly on your deck?

[leggo rocker]

Go to your local hardware or tool store and buy a small, fairly smooth round file sized just a little larger record hole.

That's the Hi-Fi solution.

The Lo-Fi technique is a small but sharp penknife - again, just a little larger than the hole in its widest point is best. Insert it into the centre hole and twist gently and briefly. Works a treat. Get rid of all the bits of wax though, they'll muck up your needle.

The ultra lo-fi solution is to make it have it, force the record on and then spend ages trying to ease it off again afterwards

[bullit]

the lo-fi technique tends to work best for me. only takes a few seconds but theres some care to be taken if you do it wrong you can mess up a record by making the hole too big.

[leggo rocker]

I guess you could always use a dremmel and grind down the spindle on the record deck.

Just kidding! Do not try this at home folks!